top of page

To install a car graphic, 

clean the surface thoroughly, position the graphic with masking tape, and use a squeegee to apply it. For larger graphics, use the "hinge method" by taping the top of the graphic to create a hinge, peeling back half the backing, and squeegeeing from the center outwards. For a smoother application, you can also use the "wet method" by spraying the surface and the adhesive with a soapy water solution to allow for repositioning before squeegeeing out the liquid. 

Step 1: Prepare the surface

  • Thoroughly wash and dry the area where the graphic will be applied.

  • Clean the surface with a solvent like isopropyl alcohol (IPA) to remove any remaining dirt, grease, or wax, and wipe it completely dry with a clean, lint-free cloth. 

Step 2: Position and secure the graphic

  • With the backing still on, position the graphic to determine the final placement.

  • Use masking tape along the top edge of the graphic to create a "hinge" that holds it in place.

  • For larger graphics, it's helpful to tape a long piece of tape across the entire top of the graphic to act as a secure hinge. 

Step 3: Apply the graphic (Hinge Method) 

  • Remove the small pieces of tape that were holding the corners.

  • Peel the backing paper off the graphic, starting from one side and pulling it down to the hinge tape.

  • Starting from the center hinge, use a squeegee to smooth the graphic onto the surface, working your way outwards from the center to push out air bubbles and excess water.

  • Remove the hinge tape and the remaining backing paper, then repeat the squeegeeing process on the other half. 

Step 4: Finish the installation

  • Carefully peel off the transfer tape from the graphic, pulling it back on itself at a sharp angle.

  • Continue to squeegee any remaining bubbles or water from the center outwards.

  • Allow the graphic to dry completely, which may take up to 24 hours before driving. 

IMG_8939.JPG

Info

Fountain Valley, CA 92708

UNITED STATES 

213-545-6678

Contact us

bottom of page